Turnigy 1/16 4WD Nitro Racing Buggy
Don't let it's small size fool you. This is a serious 1/16th Nitro Racer!
Starting with a Japanese made pull start .05 ci nitro motor, tuned pipe, shaft driven four wheel drive - with steel prop shafts and disk brake, this little buggy ticks all the boxes. It has a great range of adjust ability out of the box, such as: adjustable upper control arms, shock absorber fulcrum, shock absorber pre-load, rear suspension roll center and adjustable down stops.
A quick look over the images will demonstrate the inbuilt durability and over-engineered components such as the suspension arms, shock mounts and bulkheads. It's built more like a 1/10 scale racer than a 1/16th!
This car arrives receiver ready, completely built with the high torque steering and throttle servos installed and all linkages pre-adjusted. Just add your receiver, 4 AAA batteries, Fuel, a glow plug driver and your ready to rock!
Specs:
Servos: 15g High Torque Micro
Drive: Full Time 4WD, Twin Diff
Width: 187MM
Height: 101MM
Track: 191MM
Length: 280MM
Wheelbase: 177MM
Gear ratio: 11.2:1
Engine: .05 ci
Ground clearance (F/R): 20-30MM
Required:
2 Channel radio (TX/RX)
4 x AAA batteries for receiver
Nitro fuel
Glow plug driver
|
